The list of 01v96 1 to 8 are more or less what I would expect to see at this point. When I select any of them, and click apply, a message pops up saying that the selected ports cannot be opened at this time. Then there is also my soundcard under output ports. Rather, there is a list of 01V96 1, 01V96 2, all the way up to 01V96 8 under both input ports and output p orts. In Studio Manager under the tab, there are no input ports and output ports to select that compare to the desk. (Shut down laptop - disconnect 01v96 - restart - once booted connect 01v96 to a different USB port to one you might have used previously)
I think I had to do a full restart before the new drivers took effect. I'm sure you have already checked this but.ġ) Have you downloaded and installed the 64bit USB/MIDI drivers? (I don't think you will have any luck with the 32 bit versions) I've been using a Win7 64bit Laptop recently with Studio Manager and the 01v96. Is there some way to revert back to version 1? Maybe that would correct the problem. I have selected USB port 1-1 on the the desk for studio manager port.Ĭould it be the version of firmware on my 01V96?
I have also tried connecting with a Windows XP laptop, and am having the same problems. I am running Windows7 64bit, and have downloaded and installed all the files for this version. In 01v96 editor, there is nothing to select from the list under and. Rather, there is a list of 01V96 1, 01V96 2, all the way up to 01V96 8 under both input ports and output ports. I have downloaded all the latest versions of files associated with the 01V96 version 2, and am having the same problems as Wrhector. It might also be worth checking what versions of
If this doesn't work - tell us at what point the options deviate from what I've listed. check console device ID is (1) and all other boxes are ticked click OK (you might want to save this as a standard studio manager config) on the tab select the input ports and output ports you selected on the desk (1-1) on the tab device 01v96 to your workspace
I am sure that there is a step I am missing the software and the desk instruction manuals seem unclear on the topic, and I have read through it several times.Ĭan anyone point me in the right direction? Or state the obvious When I Right click, synchronize it just waits for a moment and says failed. Now this seems too simple just to open it up and it to work because it doesn't.ĭo I have to change something on the desk? I went into some settings and changed the studio manager to USB and tried changing the console id (updating the Studio Manager as well). I open up studio manager, Select the desk on the first tab go to the midi tab and there are a whole load of channels there.
I plug it in windows pops up and I install drivers reboot. Also this is my first time with digital mixers (Doesn't help <_< ) I have also tried on several PC's both XP (not 圆4). I have tried 2 different version of the software one on the disk which came with it and the latest version off their site. I am trying to connect a Yamaha 01V96 V2 to Studio Manager on a PC.